Intended Use; Technical Data - Würth DCN 3264 Traducción Del Manual De Instrucciones De Servicio Original

Intended use

The nailer is intended solely for connection to a
standard compressed air compressor and for the
firing of nails and staples (hereinafter referred to as
fasteners) supplied by Würth, into all types of wood.
The user is responsible for damage result-
ing from improper use.
Device protection
The maximum permissible
operating pressure (see
Technical data) must not be
exceeded. If necessary use a
pressure reducer.
Art.
Working pressure
Air consumption per second (at 7 bar)
Air connection
Noise level measurement according
to
A-weighted sound power level
Sound pressure level
Vibration emission measurement
according to
Vibrations
Weight
T nail Ø / length (T nail)
Pin Ø / Length (pin)
Staple Ø / Crown width / length (staple)
Nail Ø / length (wire magazine)
Nail Ø / length (plastic magazine)
Trigger safety mechanism
Compressed air lubricant
To avoid damage caused by contaminated com-
pressed air, a compressed air service unit must be
installed in the airline system.
Where hose lengths of longer than 10 m are used,
the device must be equipped with a small air line
lubricator because otherwise the supply of oil is not
guaranteed.
The compressed air supply must be adequately
sized!

Technical data

DCN 3264
0703 5590
5 - 8 bar
1.75 l
1/4"
EN 12549+A1
98.2 dBA
86.2 dBA
ISO 8662-11+A1
4.23 m/s
2
2.05 kg
2.1-2.9 mm/32-65
mm
2.2-2.9 mm/32-65
mm
Single/contact trigger
Art. no. 0893 0505
DKN 3065 Combi
0703 5560
5 - 8 bar
1.609 l
1/4"
96.2 dBA
88.6 dBA
3.11 m/s
2
2.95 kg
2.2 mm / 32-64 mm
2.5-2.7 mm / 44-64 mm
1.4x1.60 mm/10.7 mm/30-50
mm
1.4x1.65 mm/11.2 mm/32-67
mm
1.4x1.65 mm/11,7 mm/32-
67 mm
25