Barrette 34111487 Manual De Instrucciones página 4

3.
Measure diagonally from top of left corner rail
(A) to bottom of right corner rail (B) and note
the length. Then, measure diagonally from
top of right corner rail (C) to bottom of left
corner rail (D). Note the length. Make sure both
measurements are the same before installing
screws into uprights (Fig. 6).
4.
Install two 6" screws through each upright insert
and into the rail using the molded grooves on the
insert as a guide (Fig. 7).
NOTE:
For some styles, a #2 square extender
bit may be needed to reach the insert inside
the upright.
5.
Install upright caps onto the top of each upright
with provided vinyl cement (Fig. 8).
6.
Install hinges according to hardware instructions.
4
A
D
Fig. 6
C
B
Fig. 7
Fig. 8