Step 4: Setting Up Data Cable Connections - Promise Technology VTRAK J610s Guia De Inicio Rapido

Step 4: Setting Up Data Cable Connections

VTraks provide Direct Attached Storage (DAS) support to the Host PC.
Figure 15. VTrak J610s has one or two I/O modules
I/O module 1
(default primary)
Figure 16.VTrak J310s has one or two I/O modules
There can be one or two Input Output Modules (I/O modules) on the VTrak.
• If your VTrak has two I/O modules, I/O module 1 (on the left) is the default
primary.
• If your VTrak has only one I/O module, that I/O module is the default primary.
Under SAS specifications, both I/O modules are active at the same time. The
terms primary and secondary are for enclosure management purposes only.
To verify which I/O module is the default primary, see Chapter 3 of the VTrak
J610s, J310s Product Manual on the CD.
O
I
I/O module 1
(default primary)
Step 4: Setting Up Data Cable Connections
I/O module 2
115200
8 N 1
115200
8 N 1
I/O module 2
15
115200
8 N 1
O
I
115200
8 N 1