Mahr MarSurf PS 10 Traducción Del Manual De Instrucciones Original página 42

Power options
Dim the screen after
Enable sleep mode
after
Switch off after
Function keys
Basic settings
Remote control
Info
Operating hours
Calibration
operations
Software
Licenses
14
10 s Idle period after which the screen is dimmed and
30 s locked.
Never Tap the screen to light it up again.
Tapping the
30 s Idle period after which the MarSurf PS 10 goes into
5 min sleep mode (unless the AC adapter is connected).
When you press the green Start key the instrument
Never
will return to operating mode.
15 min Idle period after which the MarSurf PS 10 switches
30 min off (unless the AC adapter is connected).
Never
Assigns a function or parameter to the freely
programmable F1, F2 keys in the basic view.
Select the language for the text displayed.
Language
Date Enter date (the format depends on the language).
Time Enter time (the format depends on the language).
mm Select the unit of measurement "mm" or "inch".
inch
Remote control is enabled, i.e. measurements can
be started on the MarSurf PS 10 via the MarConnect
interface (see Section 5.2).
Save Saves the information as "machineinfo.pdf".
Compressed file "marlog.tar.gz" is also created, which
should be sent to Mahr Service if a fault occurs.
Battery Shows the battery capacity in %.
Probe position Shows the current probe position ("-.- - µm" when
screen is dimmed).
Measurements Shows the number of measurements performed.
Charge cycles Shows the number of charging cycles performed.
Standard mode Shows the normal operating time (in hours).
Economy mode Shows the operating time in sleep mode (in hours).
Shows the last three calibration procedures
(date, calculated correction value).
Shows the current software version of the MarSurf
PS 10.
Shows the Mahr license agreement and the list of
OSS packages used in the MarSurf PS 10 and their
licenses.
symbol unlocks the screen.
Mahr GmbH, MarSurf PS 10