Product Description; Components And Functional Elements - Renfert Twister Guia De Inicio Rapido

► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical & Electronic Technology).
EN
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
Specific Information
► Only to be used indoors. The appliance is only intended for dry operation and should not be used
or stored outdoors or in wet conditions.
► Always read the safety data sheets supplied by the manufacturers when mixing investment mate-
rials! Wear the appropriate personal protective equipment as and when required!
► Never mix flammable or explosive materials.
► Never connect the paddle without the mixing bowl.
► Manipulating the automatic bowl coupler and the intake opening can result in damage to the de-
vice and personal injury.
► Switch off the appliance when work is complete.
Authorised persons
The appliance may only be operated and serviced by trained personnel.

Product description

Components and functional elements

See Fig. 1 (on inside cover)
1
Control knob (set mixing parameters,
start, stop, aerate)
2 Parameter keys
2a Speed
2b Mixing time
2c Vacuum
3 Display
4 Sponge filter
5 Appliance switch
6 Fuse
7 Appliance socket
See Fig. 2 (on inside cover)
19 Large-scale display of parameter
(here: mixing time)
20 Parameter symbols; The symbol
„vacuum" only shows when less than
100 % vacuum has been set
Commissioning
Setup
• Operate the device at room temperature 15 - 30 ºC [59 - 86 ºF].
• Do not place the device under a source of heat.
• Do not expose the device to direct sunlight.
• Do not expose the device to high humidity.
8
Cable safety catch
9 Knurled nut
10 Silencer (Twister venturi only)
11 Compressed air connection
(Twister venturi only)
12 Inlet filter (Twister venturi only)
13 Sinter filter
14 Bowl incl. blunger
15 Pneumatic connection set
16 Mains cable
17 Compressed air hose
21 Selected speed
22 Selected vacuum level
23 Current vacuum level (bar graph)
- 2 -