BEFORE REQUESTING A SERVICE...
Problem
Frozen food in the
refrigerator
Water comes out of
the dispenser
The control display
shows tc
Drawer clings or jams
when opening or
closing.
Refrigerator doors are
not even (on French
door models)
Led Filter Status
indicator changes
to red
*Note: In case of failure of the lamps it is necessary to call the technical service.
Possible Causes
Food is too near the air outlet
in the back of the refrigerator.
The refrigerator control is too
cold
Water comes out of the
dispenser The glass does not
remain underneath
Air may be contained in the
line system
The Turbo Cool function is
activated
Drawer too full.
Realignment of doors is
required
The filter expired
What to do?
• Keep the food away from the air outlet
• Move the refrigerator control to a warmer temperature set an
increase at a time.
• Hold the glass under the dispenser for 2-3 seconds. The time after the
dispenser button is released. The water can continue to be sufficient
after releasing the button being dispensed after the button is released
• Dispense water for at least 2 minutes to remove air from the water,
causing the water system to drip after being dispensed.
• See the controls manual section
• To open: remove some of the products from the drawer when it opens
As much as possible Readjust any products left in the drawer and try to
open the drawer again.
To close: Refit the products in the drawer or remove any products that
are on the edge of the drawer and close it.
• Refer to the refrigerator door leveling section in the Owner's Manual.
• Press the Filter Status button to display the remaining filter life. If the
screen shows 0%, the filter must be replaced. When the unit has
detected a new filter (a filter has been replaced), the Filter Status LED
will blink 3 times and then remain off to indicate that the filter was
successfully replaced
25