Publicidad
Idiomas disponibles
Idiomas disponibles
13 mm
1/2 in.
WOOD STUD MOUNTING
1.
Locate studs. Verify the center of the stud with an awl or thin nail or
use an edge to edge stud fi nder.
2.
Level the wall plate [01] and mark the hole locations.
3.
Drill pilot holes as illustrated.
4.
Tighten the lag bolts [08] only until the washers [07] are pulled fi rmly
against the wall plate [01].
CAUTION: Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
Do not over-tighten the lag bolts [08].
Any material covering the wall must not exceed 16 mm (5/8 in.)
2
4
[01]
6901-170017 <02>
5.5 mm
7/32 in.
[01]
[08] [07]
?
CAUTION:
1
< 16 mm
(5/8 in.)
3
40 cm (16 in.)
63.5 mm
(2.5 in.)
3
11
Publicidad
