Safety Instructions - Ferm Industrial COM1007P Traducción Del Manual Original

Chop saw 2300W - 355mm
COM1007P
Thank you for buying this FERM product. By
doing so you now have an excellent product,
delivered by one of Europe's leading suppliers.
All products delivered to you by Ferm are
manufactured according to the highest standards
of performance and safety. As part of our
philosophy we also provide an excellent customer
service, backed by our comprehensive warranty.
We hope you will enjoy using this product for
many years to come.

1. SAFETY INSTRUCTIONS

Read the enclosed safety warnings,
the additional safety warnings and the
instructions. Failure to follow the safety
warnings and the instructions may result in
electric shock, fire and/or serious injury. Save the
safety warnings and the instructions for future
reference.
The following symbols are used in the user
manual or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Risk of electric shock
Immediately remove the mains plug from
the mains if the mains cable becomes
damaged and during cleaning and
maintenance.
Indoor use only
Class II machine - Double insulation - You
don't need an earthed plug.
Always wear eye protection!
6
Wear hearing protection.
Wear safety gloves.
Risk of flying objects. Keep bystanders
away from the work area.
The product is in accordance with the
applicable safety standards in the
European directives.
Safety instructions for Chop saws -
Cutting instructions
1. Only ever use the cutting edge (never the side)
of the disc for cutting. Avoid putting sideways
pressure on the disc, and in particular, making
it jam.
2. Keep hands and body away from the disc.
Whilst cutting with the machine, do not wear
loose clothes which could get caught in it.
3. Treat the disc cutting saw with care, never
drop it, always store it in a safe, dry place.
Avoid excessive temperatures and humidity.
4. Ensure that all disc flanges and other fitted
parts are in good condition and assembled
according to instructions. Damaged or missing
parts can lead to disc damage. Always use the
flanges delivered with the machine.
5. Never work with damaged discs, as these can
be dangerous. When changing the disc, first
switch off the machine. Rotate the disc by
hand and inspect it for unevenness, twists or
shearing. If you find any of these, get the disc
removed and replace it with a new one. Also
replace the disc if it falls to the floor. It may
have become fragile even if you cannot see
any ostensible damage.
6. Before you begin cutting, do a test run, i.e.
take a step back, switch on the motor and
ensure that the disc is functioning correctly.
After changing the disc, let the saw run for
three minutes; thereafter, before doing any
routine work, let it test-run for one minute.
7. Whilst the machine is running, never try to
remove a work piece or to clamp a work piece
in. Always wait until the disk stops turning