Ferm Industrial COM1007P Traducción Del Manual Original página 8

Max cutting capacity at 90°
- Rectangular
- L shape
- Circular
Max cutting capacity at 45°
- Rectangular
- L shape
- Circular
* For some countries cutting disk is not included.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 62841 it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-5.
Fig. A.
1. Upper safety guard
2. Movable safety guard
3. Cutting disk (*not included for all models)
4. Spark deflector
5. Workpiece clamp
Fig B.
6. Handle grip
7a. On/Off switch
7b Lock-off button
8. Carbon brush cover
9. Spindle lock button
10A. Depth stop bolt
10B. Depth stop nut
11. Transport lock pin
12. Workpiece rear clamp
13. Workpiece front clamp
8
14. Stopper lever
115mm x 125mm
15. Workpiece spindle
135mm x 135mm
16. Disk exchange wrench
Ø 125mm
Fig C.
110mm x 102mm
110mm x 110mm 3. Cutting disk
Ø 110mm
17. Machine spindle
18. Big inner washer
19. Big outer washer
20. Small washer
21. Disk bolt
3. OPERATING
Removing the transport lock
Fig. B
The machine has a transport lock pin (11) which
keeps its position low and makes it easy to
transport the device and store it. The lock button
blocks the up/down movement of the saw. And
must be de-activated before using the saw.
• Remove the transport lock by pushing the
machine down a little. While pushing down,
the transport lock pin (11) can be pulled out
with the other hand.
• After the pin (11) has been pulled out, the
machine is able to move up and down freely.
Activating the transport lock
Fig.B
• Push the machine down to its lowest position.
• Then push the transport lock pin (11) until it
slides in place.
Adding / removing a cutting disk
Fig. A, B, C.
Removing a cutting disk
• Take the disk wrench (16) from the machine
base
• Removing the disk is easier when the movable
safety guard (2) is moved up.
Before exchanging blades or adjusting
the machine, first remove the power plug
from the wall socket.
Always remove the mains plug before
changing disks
When changing disks always check
related safety instructions