Identification Label (Fig. 1); Safety Signs (Fig. 2); Assembly; Unpacking (Fig.3) - ST EL 340 Li 48L Manual De Instrucciones

J. Battery (if it is not supplied with the machine,
see chapter 13 "attachments on request"):
provides the energy for starting the motor.
Its specifications and regulations for use
are described in a specific manual.
K. Battery charger (if it is not supplied with the
machine, see chapter 13 "attachments on
request"): device used to recharge the battery.

IDENTIFICATION LABEL (Fig. 1)

3.3
Sound power level.
1.
CE conformity marking.
2.
Year of manufacture.
3.
Type of machine.
4.
Serial number.
5.
Name and address of Manufacturer.
6.
Article code.
7.
Max. motor operation speed.
8.
Weight in kg.
9.
10. Power voltage and frequency.
11. Electrical protection rating.
12. Nominal power.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorised service workshop.
IMPORTANT The example of the Declaration of
Conformity is provided on the last pages of the manual.

SAFETY SIGNS (Fig. 2).

3.4
The machine has various symbols on it.
Meaning of symbols:
Warning. Read the instructions
before operating the machine.
Danger! Risk of thrown objects.
Keep all persons away from the
work area whilst working.
Be careful when using the sharp
blade. Do not put hands or feet near
or under the opening of the blade.
The blade continues to turn even
after the motor has been switched off.
Remove the safety key (deactivation
device) before doing maintenance.
Do not expose the machine
to rain or humidity.
Be careful when using the sharp blade:
The blade continues to turn even after
the motor has been switched off
Only for electric lawnmowers
powered by mains supply.
Only for electric lawnmowers
powered by mains supply.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.
4.

ASSEMBLY

The safety regulations to follow are described in
chap. 2. Strictly comply with these indications to avoid
serious risks or dangers.
For storage and transport purposes, some components of
the machine are not installed in the factory and have to be
assembled after unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for moving the machine and its packaging,
always making use of suitable equipment. Do not use
the machine until all the indications provided in the
"ASSEMBLY" section have been carried out.
Before assembling, make sure the safety key is
not inserted in its housing.

UNPACKING (Fig.3)

4.1
GRASS CATCHER ASSEMBLY (Fig.4
4.2
4.3

HANDLE ASSEMBLY

• EL 340 Li 48L - (Fig.6
• EL 380/420 Li 48L (Fig.10
5.

CONTROLS

SAFETY KEY (DEACTIVATION DEVICE)

5.1
The key (Fig. 14.A) found inside the battery compartment
enables / disables the machine's electric circuit.
Removing the key, the electric circuit is completely
deactivated to prevent uncontrolled use of the machine.
IMPORTANT Remove the safety key whenever
the machine is unused or left unattended.
5.2

HANDLE

5.2.1 Control lever
The control lever (Fig.15.A, Fig.15.A.1) starts/stops the
motor and simultaneously engages/disengages the blade.
The positions indicated correspond to:
Start.
Blade engagement.
EN - 4
, Fig.
9)
÷
÷13
)
5)