Alessi PSJS Guia De Inicio Rapido página 2

1
Lemon Squeezer "Juicy Salif"
PSJS
This lemon squeezer, designed by Philippe
Starck in 1998, is made of aluminium casting.
Instructions for use
PLACE the lemon squeezer on a stable
surface and fit an appropriate-sized glass
underneath the tapered end of the body.
HOLD the top of one of the three supports
with one hand and with the other a piece
of fruit that has been sliced in half.
BEGIN squeezing by putting the fruit on
the rounded tip of the body and press lightly,
making slow rotating movements at the same
time. The liquid produced will run down
the body of the lemon squeezer and into
the glass below (fig. 1).
AFTER USE, rinse immediately under
running water (fig. 2), and dry. Remember
that the use of abrasive detergents may
cause damage to the surface finish.
NOTE: aluminium, the metal which
"Juicy Salif" is made of, is sensitive to
elements in the atmosphere.
2
If the lemon squeezer is not used with
frequency, it is advisable to discard the
first squeeze, in order to avoid any possible
bad flavours.
Furthermore, particularly in marine
climates, it is possible that stains may
form as a result of oxidation, but these in
any case do not compromise the quality
of the juice squeezed.
The rubber feet situated at the end of the
three supports are replaceable. Thus, in
case of loss or wear, a new piece can be
obtained from your dealer. This product
28882 Crusinallo (VB) Italia
cannot be put in the dishwasher.
telefono (0323) 868611, fax (0323) 641605
sac.alessi@alessi.com