Publicidad
Saunaofen mit integrierter Steuerung
all bracket
Securing
scre s ood
scre s
Scre s
M
erminal bo
oot
Scre s M
17.05.18
Technische Änderungen, Druckfehler und Irrtümer vorbehalten
Aufbau
Sel tapping
scre s
ottom panel
N o t e :
he control e ui
ent a be destro ed e en if it is incorrectl
connected onl once he arrant ill be oided if the electrical
c o n n e c t i o n i s n o t c o r r e c t .
nstructions for the electrician
IN V E
and ccident Prevention Regulation GV
observed or connecting the stove and all electrical s stems n e ter-
nal all pole disconnecting device ith ull isolation according to overvol-
tage categor III must be installed
I m p o r t a n t :
Mains connection leads must be e ible cables ith pol chlorophene
sheaths No connection leads are supplied ith the stove ll the ables
installed inside the cabin must be suitable or an ambient temperature
o at least
C heat resistant silicon cables must be used he mini-
mum cross section o the connection cable and the minimum size o
the sauna cabin are sho n in the table able page Make the elec-
trical connection as sho n in the connection diagram connection
diagram is additionall a
ver a ter making the electrical connection Please note that live cables
must not be routed visibl on the internal alls o the cabin or sa et
reasons In pre abricated sauna cabins the all element ith the air
suppl opening generall has empt cable conduits or a duct or routing
the cable I our cabin does not have an cable routing preparations
e recommend that ou install a connection socket not supplied to the
outside o the cabin rill a hole in the cabin all near the cable in eed
rom the stove and the connection socket hread the cable through the
hole to the e ternal connection socket ll cables must be protected
rom damage his can be achieved using installation ducting/piping or
using ooden covers
onnection diagra
9 k W s a u n a s t o v e w i t h i n t e r n a l c o n t r o l l e r
T e s t i n g t h e i n s u l a t i o n r e s i s t a n c e
he resistance values bet een the various conductor terminals and
the housing protective earth can be measured using an insulation
resistance measuring unit he total insulation resistance bet een the
conductor terminals and housing protective earth must de nitel be
greater than M hm hm values o the stove
sauna heater
ed to the inside o the duct cover it the co-
or k
must be
8
Publicidad
