Sterilising; Assembly (Figure ➀); Power Supply (Figure ➁); Mains Operation - NUK e-MOTION Manual Del Usuario

eMotion 1.0 0910 Cluster 1 Seite 21 Montag, 6. September 2010 6:31 18

5.3 Sterilising

Before sterilising, clean as described in section
"5.2 Cleaning (Figure ➀ in reverse order)".
The motor unit and adapter (parts
Important!
11 - 19 ) should never be sterilised as this may
damage the electrics.
• Use a NUK Steam Steriliser, observing the
relevant operating instructions, or sterilise
the parts in boiling water for 5 minutes.
1. Insert the valve into the breast shield
1
with the knob pointing upwards.
2. Position the motor unit
shield .
2
3. Screw the connection ring
onto the motor unit
12

7.1 Mains operation

For only use the enclosed
mains operation
adapter, model KSS 07-045-0800 (KSD10-045-
0800).
1. Open the battery compartment by the catch
lock 15 .
2. Insert the plug 11 on the
adapter into the socket
18
in the battery compartment.
3. Close the battery compartment again.
Push both the "feet" on the
lid into the relevant recess
on the motor unit and shut
the lid, ensuring the catch
lock 15 engages with click.
The device should not
Note:
be operated without the
battery compartment lid.
Caution!
microwave, as this can result in damage to the
material.
Important!
parts have completely cooled and dried before
using again.
6. Assembly
4. Insert the lip valve
2
12 on the breast 5. Screw together the assembled motor unit
from below
3
.
7. Power Supply
4. Fit the interchangeable plug attachment
5. Plug the mains plug
21
Ensure there is sufficient water in the sauce-
pan to avoid damage.
Parts should not be sterilised in a
Ensure that the accessories and
➀
(Figure )
from below into the
4
assembled breast shield 2 .
and the bottle .
5
➁
(Figure )
suitable for your power supply to the adapter.
You can find out which plug is suitable for
your country from the below section.
into a wall socket.
18
12
19