Preparations For Use - Dräger X-plore 8000 Instrucciones De Uso

en |
Use
The visor's date of manufacture is coded: the year is specified in figures, the
quarter in dots.
Code
14
14
Symbol Explanation
Follow the instructions for use
Maximum storage area humidity ≤ 90 %
<90%
+55°C
Storage temperature range -5 °C to +55 °C
-5°C
4 Use
4.1

Preparations for use

NOTICE
Ensure that the visor bracket is inserted into the adaptor on the helmet as far as
it will go.
Perform the following activities prior to use:
®
1. Check that the Dräger X-plore
chapter 5.2.1 Checking serviceability).
2. Adjust the support ring to the user's head size (see chapter 4.1.1 Adjusting
the support ring).
18
Meaning
3rd quarter 2014
4th quarter 2014
8000 helmet with visor is ready for use (see
3. Adjust the face cuff to the head size (see chapter 4.1.2 Adjusting the face
cuff).
4. If necessary, attach the earmuffs (see chapter 4.1.3 Attaching the earmuffs
(optional)).
5. Remove transport foil from visor.
6. If necessary, attach a protective foil (see chapter 5.2.5 Replacing the
protective foil).
7. Connect powered air purifying respirator or air line breathing apparatus:
Fasten the corrugated hose to the device and helmet, and check for secure
fitting.
8. Switch on the device and check whether air is coming out at the front of the
ventilation duct.
®
9. Don the Dräger X-plore 8000 helmet with visor (see chapter 4.1.4 Donning
®
the Dräger X-plore 8000 with visor).
4.1.1 Adjusting the support ring
NOTICE
To increase the size of the support ring, press lightly on the end into which the
support ring is threaded.
1. A scale has been provided for the support ring. Slide the ends of the support
ring into each other until the support ring is the right size for the user's head
circumference.
 Illustration on the fold-out page (figure D)
2. Adjust the support ring in such a way that it rests on the head above the
ears. For this purpose, several slots have been provided for the 4 flaps on
the support ring. Attach the flaps to the knobs on the head harness.
 Illustration on the fold-out page (figure A-1)
4.1.2 Adjusting the face cuff
Illustration on the fold-out page (figure B)
– Adjust the Velcro tabs so that the face cuff rests tightly against the user's
face.
Instructions for use |
Dräger X-plore 8000
®
Helmet with Visor