Important Instructions - Muskoka MPF-BWL Manual Del Usuario

Important Instructions

Important: Read all instructions and warnings carefully before starting installation. Failure to follow
these instructions may result in a possible electric shock, fire hazard and will void the warranty.
When using electrical appliances, basic precautions should always be followed to reduce the
risk of fire, electrical shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided,
use handles when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 3 feet (0.9 meters) from the front of the heater and
keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whe
ever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been
dropped or damaged in any manner. Return heater to authorized service facility for examination,
electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other water container.
8. Do not run power cord under carpeting. Do not cover power cord with throw rugs, runners, or
the like. Arrange power cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may
cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block heater air intakes or exhaust in any manner. Do not operate
heater on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arching or sparking parts inside. Do not use in areas where gasoline, paint, or
flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.
14. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord
or relocatable power tap (outlet/power strip).
15. This heater has a self-protection function. If the heater does not operate normally, re-set the heater
by unplugging the power cord from the outlet for 30 minutes. Plug the heater back into the outlet. If
it still does not work, please send the heater to the nearest customer service center for repair.
16. The heat and flame functions may not work immediately if used in cold temperatures (below 5˚C).
The unit will warm up and operate normally after 30 minutes of continuous operation.
IMPORTANT: SAVE THESE INSTRUCTIONS.
CautIon: to prevent eleCtrIC shoCk, matCh wIde blade of plug to wIde slot
of the eleCtrICal outlet and Insert fully.
CoNsUmER sAFETy INFoRmATIoN:
ThIs APPlIANCE hAs A PolARIzED PlUg (one blade wider than the other). To re-
duce the risk of electrical shock, this plug is intended to fit in a polarized outlet one
way only. If the plug does not fit fuly in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do NoT ATTEmPT To moDIFy ThIs PlUg oR DEFEAT ThIs sAFETy FEATURE IN ANy WAy.