Installation Of The Remote Control; Using The Remote Control - SPORTSTECH Desk Fit DFT200 Manual Del Usuario

INSTALLATION OF THE REMOTE CONTROL

You should hold the remote control in your hand when using your DeskFit200 in order to ensure that you can
stop your device at any time in an emergency situation.
As shown in the following pictures, insert two Micro AAA batteries (1.5V) into the remote control.
+ Accelerate the treadmill
The remote uses a 2.4G radio control. Connect the remote control to your device so that it does not interfere
with other treadmills.
How to connect your remote:
1. Connect the treadmill and turn it on. The LEDs brighten after a long "ring".
2. Press the remote control [SPEED +] and [SPEED] buttons simultaneously, release the the
buttons until the red lamp and the green lamp light up alternately. Now you will hear two
sounds, and the LEDs go off. The remote control and the treadmill are connected.
Starting function: In standby mode, press the START/STOP button to start the treadmill.
Stop function: Press the START/STOP button for approx. 3 seconds to stop the treadmill directly.
Pause function: Briefly press the START/STOP button once to pause the treadmill. The device continues to
record the data.
Quick stop function: Press START / STOP 3 times or more to stop the treadmill instantly.

USING THE REMOTE CONTROL

- Decelerate the treadmill
28
On/off switch