For Your Safety - Wurth Master WS 115 S 750 Manual Del Usuario

Working safely with this machine is possible only when the op-
erating and safety information are read completely and the in-
structions contained therein are strictly followed.
If the cable is damaged or cut through while working, do not
touch the cable but immediately pull the mains plug. Never use
the machine with a damaged cable.
Wear protective goggles, ear protectors and face mask.
Wear protective gloves and sturdy footwear.
Always hold the machine with both hands when working and
provide for secure footing.
For all work with the machine, the auxiliary grip 4 must be mounted.
When working with a roughing or cutting disc, the guard 8 must be mount-
ed. When working with the rubber backing plate or with the cup/disc
brush, the hand protector 13 (accessory) should be mounted.
Use only grinding tools whose allowable speeds are at least as high as the
highest no-load speed of the machine.
The centre hole of the grinding/cutting disc must fit the centring shoulder of
the mounting flange 9 without play. Do not use reducer piece or adapter.
Before switching on, check if the grinding disc is properly mounted and can
turn freely.
For the mounting and use of the grinding tool, observe the instructions of the
manufacturer.
Test run new grinding tools at the highest no-load speed for at least
30 seconds.
Damaged, out of balance or vibrating grinding wheels must not be used.
Protect the grinding wheels from shock, impacts and grease.
The machine can be used only for dry grinding and cutting.
When cutting masonry, use the depth guide, guard and dust vacuuming.
The vacuum cleaner must be suitable for masonry dust.
Do not work with material containing asbestos.
Do not clamp the machine in a vice.
Always direct power cable to rear away from machine.
Apply the machine to the material to be worked only after it has been
switched on.
Keep hands away from rotating grinding wheels.
Be careful of hidden electrical lines or gas and water pipes. Check the work-
ing area, e.g., with a metal detector.
When grinding metal, sparks are generated. Pay attention that no persons
are endangered. Because of the danger of fire, no combustible material
must be present in the area of flying sparks.
Pay attention to the direction of rotation. Always hold the machine such
that sparks and grinding dust fly away from the body.
Caution! The grinding tool runs on after the machine has been switched off.
Cutting discs that are running on should not be braked to a stop with side
pressure.
Use only genuine Würth-accessories.
For further notes on safety refer to enclosed sheet.

For your Safety