Tabla de contenido
Publicidad
POWER AMPLIFIER SECTION:
General:
Bi-amp system with independent,
class-D, bridge-tied load outputs
crossed over at 3KHz (24dB/octave
filter)
Amplifier frequency response = 20 –
20KHz
Power Consumption:
USA/Japan: 100 – 120vac 50/60Hz =
90 Watts
Europe/Other: 220 – 240vac 50/60Hz
= 90 Watts
Rated Power:
*Measurements taken at 120vac line;
channels measured independently;
ratings at <5% THD
104 Watts continuous into 8 ohm,
series woofer load (400Hz sine wave)
104 Watts continuous into 8 ohm,
planar tweeter (5KHz sine wave)
PREAMP SECTION:
Channel 1 / Channel 2:
Input impedance = 3M ohm (1/4"
jack); <10K ohm (balanced XLR)
Phantom power = +48V (XLR) / +9V
(1/4" jack)
Nominal signal input level = -11.7dBu
Maximum signal input level =
+4.69dBu
Channel 3 / Aux In:
Input impedance = 330K ohm (front
1/4" jack); 10K ohm (rear, summed
phono jacks)
Nominal signal input level =
-6.90dBu
Maximum signal input level =
+20dBu
ECOUSTIC
®
SPECIFICATIONS
DIGITAL SECTION:
32-bit floating point DSP
Audio converter = 24-bit
Sample rate = 48kHz
System latency = 0.5ms
PATCHING INPUT/OUTPUT JACKS
CHANNEL 1 & 2 DI / MASTER LINE
OUT:
XLR/DI output impedance = 200 ohm
Minimum load = 600 ohm
Maximum signal output level =
+20.4dBu
SYSTEM NOISE (A-WEIGHTED)
Channel 1 DI = 89.8dB
Channel 2 DI = 84.1dB
Master line out = 80.4dB
STEREO LINK OUTPUT:
*Output is right channel of the digital
effects; E300 outputs left channel in
this mode
Output impedance = 200 ohm
Minimum load = 600 ohm
Maximum signal output level =
+4.08dBu
Noise floor = 79dB (A-weighted)
POWER AMP INPUT:
Input impedance = 10K ohm
Nominal signal input level =
+2.22dBu
Maximum signal input level =
+7.32dBu
DIMENSIONS/WEIGHT
Width = 23.75" (60.33 cm), Height
= 15.38" (39.06 cm), Depth = 13.63"
(34.62 cm)
49.5lbs. (22.5 kg)
22
E300
Publicidad
Tabla de contenido
