Properties Of Tool; Product Features; Intended Use; Symbols - Protool DWP 4000 DEC Manual Original / Lista De Piezas De Repuesto

2

Properties of tool

2.1 Product features

Your PROTOOL drywall screwdriver features
the following properties:
- Power tool switches off electronically and
accurately without wear and tear upon
reaching the specifi ed screwing depth
- Automatic motor stop off at the end of
the working operation
- Serial screwing in "AUTO" mode without
main switch operation
- Gradually regulated speed
- Heat protection, under- and overvoltage
protection, dynamic current restriction
protects the power tool
- Brushless EC Motor resistant to wear and
tear

2.2 Intended use

The PROTOOL drywall screwdriver is de-
signed for the following works:
Main use
Plasterboard for
metal sections
(≤ 0.88 mm)
Plasterboard for
metal sections
(≤ 2.25 mm)
Plasterboards for
wooden structures
Particleboards for
wooden structures
The user is responsible for any damages
and injuries caused by use which does not
conform to the intended purpose; including
any damages and wear caused by perma-
nent industrial use.
14
Screw type
Drywall screws
with fi ne thread
Drywall screws
with drilling tip
Drywall screws
with rough thread
Drywall screws
with rough thread
3

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Wear ear protection!
Wear a dust mask!
Wear eye protection!
Read the instructions
Do not dispose of power tools into
household waste!
Advice or tip
►
4

Safety instructions

- Before using the power tool, carefully
read all of the attached safety instruc-
tions and this operating manual.
- Keep all of the attached documents and
pass on the documentation if the ma-
chine changes ownership.
4.1 Safety instructions specifi c
to the given tools
- Adhere to the following safety guidelines,
which come with every product.
- Do not open the power tool. Even after
disconnection from the mains, there is
still a high capacitor voltage inside the
power tool.
- Before every use of the tool inspect the
fl exible power cord and power plug. Have
defects remedied by an expert.
- The tool must not be used in damp and
wet areas, outdoors in the rain, fog, snow
and in areas where there is a danger of
explosion.
- Before connecting to the power source
the switch must be in the off position.
- The fl exible power cord must always be
directed from the tool to the back. The
fl exible power cord must not be strained
by pulling and must not lie on or go over
sharp edges.
- Ensure that you are in a fi rm and safe
posture when working.