Commercial Electric 842-401 Manual De Instrucciones página 4

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
1ea Canopy (#1)
1ea Loop (#5) 6ea Lock Nuts (#7, #13)
ASSEMBLY INSTRUCTIONS:
1. Carefully unpack the fixture. Lay out all parts on a clean surface.
2. Screw the Loop (#5) onto Nipple A (#6). Use pliers and a screwdriver to twist open the link
(cover the chain with cloth to prevent damage to the link finish) at the end of the Chain (#3)
not attached to the Screw Collar Loop (#2). To avoid damage to the link, only open the link
enough to hook it onto the Loop (#5). Hook the open link to the Loop (#5) and then close
the link.
3. Screw the Tube (#10) onto Nipple B (#14).
4. Place the hole located on the bottom of Curve Arm A (#9) onto Screw (#11) on Curve Arm B
(#12), and secure Curve Arm A (#9) by screwing the Lock Nut (#13) onto the Screw (#11).
Place the Screw (#8) located on the top of Curve Arm A (#9) into the hole located on the
Cup (#19), and secure Curve Arm A (#9) by screwing the Lock Nut (#7) onto the Screw (#8).
Repeat for the other two Curve Arms A (#9).
5. Weave the fixture wires up through the Chain (#3), through the Ring (#4), through the Screw
Collar Loop (#2), through the Canopy (#1), and through the Nipple (#25 on Page 7) on the
Mounting Strap (#24 on Page 7). Screw the Nipple (#25) into the Screw Collar Loop (#2).
6. Unscrew the Socket Rings (#16) from the Sockets (#18). Place the Shades (#17) over the
Sockets (#18). Screw the Socket Rings (#16) onto the Sockets (#18) to secure the Shades
(#17).
7. Install three 60 watt medium base incandescent light Bulbs (#15) (not included) or three
equivalent standard base compact fluorescent light bulbs (not included) in the three Sockets
(#18) in the fixture.
Page 4
1ea Screw Collar Loop (#2)
3ea Screws (#8)
3ea Curve Arms A (#9)
6 feet Chain (#3)
3ea Socket Rings (#16) 3ea Shades (#17)
1ea Ring (#4)