Hi-Pass Filter Menu; Battery Type Menu - HHB FlashMic DRM85 Manual Del Usuario

Hi-pass Filter Menu

This menu will not be available if 'Enable Configuration changes in DRM' was set to 'No'
when the configuration file was defined in FlashMic Manager.
The FlashMic's analogue circuitry includes a hi-pass filter, to assist in the rejection of
extraneous low-frequency background noises, such as air-conditioning noise or traffic
rumble. The filter has a slope of dB/oct. and a turnover frequency of 00Hz.
The filter is set to be in or out of circuit in the FlashMic Manager software for each preset,
and is loaded into the FlashMic with the configuration file. However, the filter may be
switched in and out of the recording chain via the menus.
To enter the Hi-pass filter Menu, enter MENU mode by pressing the M/STOP button, and
then make SHORT DOWN TURNs of the jogswitch until the display shows
Select this with a SHORT PRESS, and the display shows either
can be switched in or out with SHORT TURNs of the jogswitch. A SHORT PRESS selects the
setting. The display will then show OK to confirm.

Battery Type Menu

This menu will not be available if 'Enable Configuration changes in DRM' was set to 'No'
when the configuration file was defined in FlashMic Manager.
The FlashMic may be powered by rechargeable or alkaline batteries. The two types of battery
have different discharge characteristics, and for the battery status symbol in the LCD
display to reflect the battery's remaining charge as accurately as possible, it is necessary
to set the battery type menu parameter to match the batteries being used.
The battery type is set in FlashMic Manager as a 'global' setting, which is applicable to all
presets in one configuration file, and is not selectable to the different types for different
presets. The setting may be overridden via the Battery Type Menu.
To enter the Battery Type Menu, enter MENU mode by pressing the M/STOP button, and
then make SHORT DOWN TURNs of the jogswitch until the display shows
Select this with a SHORT PRESS, and the display shows either
(rechargeable). The battery type can be changed with SHORT TURNs of the jogswitch. A
SHORT PRESS selects the setting. The display will then show OK to confirm.
En.0
HIPASS
Hi-pass Filter Menu Display
BATTYP
Battery Type Menu Display
.
HIPASS
or . The filter
HP ON HP OFF
.
BATTYP
(alkaline) or
ALKLIN RECBLE