Explanation Of The Symbols On The Equipment - Toolson PRO-AS 360 Traducción De Las Instrucciones Originales De Funcionamiento

Explanation of the symbols on the equipment

Introduction
MANUFACTURER:
scheppach Fabrikation von
Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment and
success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non­compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non­original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs due
to the non­compliance of the electric regulations and
VDE regulations 0100, DIN 57113 / VDE0113.
WE RECOMMEND:
Read through the complete text in the operating instruc­
tions before installing and commissioning the device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan­
tage of its application possibilities in accordance with the
recommendations. The operating instructions contain
important information on how to operate the machine
safely, professionally and economically, how to avoid
danger, costly repairs, reduce downtimes and how to in­
crease reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula­
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
12 І 136 12 І 136
GB Caution - Read the operating instructions to reduce the risk of inquiry
GB Protection class II
GB For use in dry rooms only
Output connector of the charging unit (direct current): The outer part of the con­
GB
nector is the negative pole and the inner part is the positive pole.
carefully follow its information. The machine can only be
operated by persons who were instructed concerning the
operation of the machine and who are informed about
the associated dangers. The minimum age requirement
must be complied with. In addition to the safety require­
ments in these operating instructions and your country's
applicable regulations, you should observe the generally
recognized technical rules concerning the operation of
woodworking machines.
Device Description (Fig. 1)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Locking sleeve
Unpacking
• Open the packaging and remove the device care­
• Remove the packaging material as well as the pack­
• Check that the delivery is complete.
• Check the device and accessory parts for transport
• If possible, store the packaging until the warranty
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
Intended use
The cordless screwdriver is designed for tightening
and undoing screws.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of mis­
use. The user / operator and not the manufacturer will
Bit chuck
Lamp
Torque selector
Battery capacity indicator
Charging connection
On/Off switch
Clockwise/Counter-clockwise selector switch
Charging unit
Charging cable
fully.
aging and transport bracing (if available).
damage.
period has expired.