Briteq Powermatrix 5x5 RGB Manual De Instrucciones página 15

ENGLISH
125 channel DMX-Mode: individual pixel control for RGB + MASTER DIM + SOUND/STROBE
Each of the 25 pixels has individual control for RGB, master dimmer and sound/strobe, pixel mapping
possible.
Channel: Value:
1
000-255
2 000-255
3 000-255
4 000-255
000-004
005-024
5
025-034
035-255
...
121 000-255
122
000-255
123
000-255
124 000-255
000-004
005-024
125
025-034
035-255
131 channel DMX-Mode: combination of 125CH and 6CH modes
This is a combination of 2 channel modes: background color control for all 25pixels individually (pixel
mapping) + FX-control for the internal effects library.
Background color control: channels 1 to 125
Channels 1 to 125 are the exact same channels as in the 125CH-mode.
FX-pattern control: channels 126 to 131
Channels 126 to 131 are exactly the same FX-channels as channels 1 to 6 in the 6CH-mode.
One important difference for CH131 (background color): for DMX-values 000-012, the
background colors are controlled by channels1 to 125! This means that the internal effects and
background work in 2 completely independent layers.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
BRITEQ
®
Function:
Pixel 1 - Red (0-100%)
Pixel 1 - Green (0-100%)
Pixel 1 - Blue (0-100%)
Pixel 1 - Dimmer (0-100%)
ON
Sound control (7 colors)
ON
Strobe
... ...
Pixel 25 - Red (0-100%)
Pixel 25 - Green (0-100%)
Pixel 25 - Blue (0-100%)
Pixel 25 - Dimmer (0-100%)
ON
Sound control (7 colors)
ON
Strobe
13/83
OPERATION MANUAL
Remarks
CONTROLS FOR PIXEL 1
Audio sensitivity: 191=low ~ 200=high
Increasing speed: 201=slow ~ 247=fast
CONTROLS FOR PIXEL 25
Audio sensitivity: 191=low ~ 200=high
Increasing speed: 201=slow ~ 247=fast
POWERMATRIX5x5-RGB