Auto Power Off - Fluke Networks SimpliFiber Pro Guía De Uso


The LOW BATTERY LED blinks continuously if the battery is
low. The LED blinks occasionally if auto power-off is
disabled. See "Auto Power-Off".

Output port with SC adapter.
Battery Installation, Life, and Status
Note: Fluke Networks recommends alkaline batteries.

The batteries last for about 40 hours of typical use. See the
specifications.

Replace the batteries if the LOW BATTERY LED blinks
continuously. The LED blinks occasionally if auto power-off
is disabled. See "Auto Power-Off".
Auto Power-Off
If auto power-off is enabled, the source turns off after 30
minutes if no keys are pressed.
To disable or enable auto power-off, hold down
seconds.

If auto power-off is enabled, all LEDs turn on for 3 seconds.

If auto power-off is disabled, all LEDs blink for 3 seconds
and the LOW BATTERY LED blinks occasionally.
Registration
Registering your product with Fluke Networks gives you access
to valuable information on product updates, troubleshooting
tips, and other support services. To register, fill out the online
registration form on the Fluke Networks website at
www.flukenetworks.com/registration.
Battery Installation, Life, and Status
AA
IEC LR6
NEDA 15A

for 4
FFT02.EPS
5