Hoover Dust Manager Cyclonic Manual Del Usuario página 3

• Remove excess water with a dry cloth and leave to air dry for 24 hours or until
fully dry (Y).
• After completing the washing and drying operations, locate the filters in their
original positions in the cleaner.
REMOVING A BLOCKAGE FROM THE
SYSTEM
If there is a noticeable drop in the performance see the following 2 points:
1) Check if the Cyclonic Cassette is full (If so refer to chapter "Emptying The Dust
Manager Cyclonic Cassette"
2) If not full then:
a) Have you cleaned the Cyclonic Cassette filters recently? If not please refer to
the chapter "Filter Maintenance".
b) Check if there is any other blockage in the system.
• Use a rod or pole to remove any blockage from the tubes and flexible hose.
• It may also be possible to remove an obstruction in the flexible hose by lightly
squeezing or bending it.
• Check and clean if required the underside of the nozzle by using the crevice tool.
SIMPLE USER CHECK LIST BEFORE
CALLING FOR SERVICE
1) Is there a working electricity supply to the cleaner? Check with another
appliance.
2) Is there a restriction?
a) Is the Cyclonic Cassette full? Please refer to the chapter "Emptying The Dust
Manager Cyclonic Cassette.
b) Are the filters or Cyclonic Cassette blocked? Please refer to chapter "Filter
Maintenance".
c) Is the hose or nozzle blocked? Please refer to chapter "Removing A
Blockage from The System".
3) Has the cleaner automatically switched off? In this case the Overheating
Protection has been activated. Please refer to chapter "Features", paragraph
"Overheating Protection".
Please remember that:
1) Some carpets can cause a small build up of static electricity. Any static
discharge is not hazardous to health or the product.
2) A service charge will be made if the cleaner is examined and found in working
order, has not been assembled in accordance with these instructions, or has
been misused.
GB