Environmental Protection - Worx Sonicrafter WX677 Manual Original

DISpOSAL OF AN
EXHAuSTED BATTERy
pACk
To preserve natural resources,
please recycle or dispose of
the battery pack properly.
This battery pack contains Lithium batteries.
Consult your local waste authority for
information regarding available recycling and/
or disposal options. Discharge your battery
pack by operating your tool, then remove the
battery pack from the tool housing and cover
the battery pack connections with heavy-duty
adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or
remove any of the components.
WORkINg HINTS FOR yOuR
TOOL
If your power tool becomes too hot,
especially when used at low speed, set the
speed to maximum and run it with no load
12
for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds. Always
keep the blade sharp.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the cutting or sanding finish.
Start your tool before working and turn it off
only after you stop working.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away , it
will damage the sanding pad. The guarantee
does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for finishing surfaces. If necessary, first make
a test run on scrap material.
Excessive force will reduce the working
efficiency and cause motor overload.
Replacing the accessory regularly will
maintain optimum working efficiency.
High Frequency Multi-function Tool
MAINTAIN TOOLS WITH
CARE
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
ENVIRONMENTAL
pROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
EN