Important Safety Instructions; Special Instructions; Description Of Device - Singer SNG 7.24 Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24

IMPORTANT SAFETY INSTRUCTIONS

When using your flatiron, basic safety precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not immerse the iron in water or othe
liquids.
3. The iron should always be turned to "min", before plugging or unplugging from outlet.
Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.
Loop cord loosely around iron when storing.
5. Always disconnect iron from electrical outlet when filling with water or emptying and
when not in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped or dam-
aged. To avoid the risk of electric shock, do not disassemble the iron. Take it to a
qualified serviceman for examination and repair. Incorrect reassembly can cause a risk
of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or near children. Do
not leave iron unattended while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution
when you turn a steam iron upside down – there may be hot water in the reservoir.
9. If the malfunction indicator goes on, the flatiron is not operating normally. Disconnect
from the power supply and have the flatiron serviced by qualified service personnel.
10. The iron must be used and rested on a stable surface.
11. The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it is leaking.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance on the
same circuit.
2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords
rated for less amperage may overheat. Care should be taken to arrange the cord so
that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
More specifically:
DO NOT
let children or untrained persons use the appliance without supervision.
immerse the iron, cable or plug in any liquid.
NEVER
DO NOT
leave the hot iron touching fabrics or very inflammable surfaces.
DO NOT
leave the appliance unnecessarily plugged in. Disconnect the plug from the
mains when the appliance is not being used.
NEVER
touch the appliance with wet or damp hands.
DO NOT
use the power cord or the appliance in order to pull the plug out of the
socket.
DO NOT
leave the appliance exposed to the weather (rain, sun, etc. ).
DO NOT
leave the iron without supervision when it is connected to the power supply.
fill the reservoir with water before removing the plug from the socket.
DO NOT
PLEASE NOTE!
Do not use chemical additive, scented substances or decalcifiers. Failure to com-
ply with the above-mentioned regulations leads to the loss of guarantee.

DESCRIPTION OF DEVICE

A. Plate with steam vents
C. Filler cap
E. Shot-steam button
G. Sleeving
I. Thermostat knob
K. Calc-Clean button
2
B.Spray organ
D. Steam dial
F. Spray button
H. Power light //Auto shut off light
J. Transparent water tank
L. Maximum filling level

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sng 5.20

Tabla de contenido