Residual Risks; Safety Instructions; Setting / Adjustment; Assembly - Mafell S 200 Traducción Del Manual De Instrucciones Original

2.8 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Emission of dusts during extended operation with
damaged folded filter.
- When the shavings bag is emptied, it cannot be
ruled out that dust is inhaled (use respiratory
protection with particle filter P2 or P3).
- Unauthorised changes to the device exclude the
manufacturer's liability for any damages resulting
thereof.
3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
- The device may only be transported by crane by
hooking in at the two lateral handles 8 (Fig. 1)! Do
not lift by the rear handle 10 or by the handle of the
dust extractor 9.
- In addition, all the safety instruction for dust
extractor S 35 M are applicable (see operating
instructions Art.-No. 170425 or Art.-No. 170246)
4

Setting / Adjustment

4.1 Assembly


Put the kink protection that is included in the
delivery (Fig. 1) over the suction hose so it is
flush with the extraction hose fitting 2.

Pay attention that the two snap locks 3 (Fig. 1)
of the dust extractor have safely engaged in the
recesses on the cover.

Push the extraction hose fitting 2 (Fig. 1) over
the cover's suction opening 4 and turn it until the
hose fitting engages.

Only operate the dust extractor in a vertical
position.
Danger
This device may contain hazardous
dust. Emptying and maintenance
operations including the disposal of
dust collection containers may only
be carried out with appropriate
protective equipment.

4.2 Changing the 200l shavings bag


Use respiratory protection with particle filter P2
or P3 and only empty the shavings bag
outdoors.

Switch on the dust extractor and afterwards
shake the folded filter cartridges. Switch off the
dust extractor.

Remove the suction hose. Close the suction
fitting with the closure 5 that is included in the
delivery (Fig. 2).

Open the clamping ring 6 (Fig. 2) and remove
the dust extractor and cover. Then carefully
remove the shavings bag and close it with the
sewn-on ribbons.

Insert the empty shavings bag 7 (Fig. 2) by
means of the elastic band such that the
inspection glasses are on top of each other.

4.3 Disposal of vacuumed material


Dispose of
accordance with the statutory provisions and the
datasheet of the insulating material board
manufacturer.
5

Operation

Information can be referenced in the operating
instructions (Art.-No. 170425 and 170426) of dust
extractor S 35 M.
Do not fill the shavings bag above the "max." marking
(risk of hose clogging).
On completion of work, but especially if you do not
intend to use the device for a longer period of time,
you should:

Use respiratory protection with particle filter P2
or P3 when you empty the shavings bag.

Store the extraction hose such that there are no
kinks.

Neatly reel up the mains cable and protect it
against damage.
-14-
the vacuumed material in