Rear Panel - Peavey MAX Serie Manual De Operación

Rear Panel

AUX INPUT
12
This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX
and play along
POWER SWITCH/DDT
13
This dual-purpose switch is used to turn the amp on and off. When the DDT (Distortion Detection
Technique) senses power amp clipping, a protection circuit is engaged and the LEDs in the power switch
change to red.
CAUTION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous
energy can be present inside the chassis even when the on/off switch is in the OFF position.
AC POWER INLET:
14
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
15 this connector to provide power to the unit. Damage to the equipment may result if improper line volt-
age is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used, and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and
all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-
low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored
green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is
marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the
terminal that is marked with the letter L, or the color red.Putet, quisci tisl et adionsenibh esequi ting et
14
INDICATOR LIGHT
™
15
Series bass amp
®