Important - GAPOSA EMITTO SLIM LINE QCTX1 Manual De Instrucciones

RESET TRANSMITTER MEMORY (DELETING ALL THE TRANSMITTERS OR CHANNELS OR
SENSORS)
Option 1 (Fig. 3.1)
Using an already programmed transmitter press and hold both PROG-TX and STOP buttons
till the motor makes first a brief jog and, after a while, a second long jog. Memory is now
empty.
Option 2 (Fig. 3.2)
1. Without an already programmed transmitter switch the motor power supply OFF. Then
switch it ON.
2. Within 8 seconds, using any Gaposa transmitter, press and hold both PROG-TX and STOP
buttons until the motor makes a long jog.
Memory is now empty.
LIMIT SWITCH SETUP (ATTENTION: Just for motors with electronic limit switch).
ALWAYS SET THE UP LIMIT SWITCH FIRST.
1. Push PROG-FC till the motor makes a brief movement in both direction
Note: during "programming mode" the operations are in "deadman control"
2. Press and hold the UP button and run the motor to the desired UP limit position.
3. Press STOP to set the UP limit position. The motor makes a brief jog.
4. Press and hold the DOWN button and run the motor to the desired DOWN limit position.
5. Press STOP to set the DOWN limit position. The motor makes a brief jog.
Note: Accurate limit setting can be performed when UPWARD or DOWNWARD by pressing
a second time PROG-FC: the motor then moves slowly in steps towards to the desired limit.
Always press STOP button to set the limit position.
AUTOMATIC SETTING OF THE LIMITS
For limits set with torque sensor ( mechanical stop of shutters or cassette awnings/sha-
des), press and hold UP button until the bottom bar hits the cassette or shutter box.
A short jog will indicate that the UP position has been memorized. The same procedure can
be followed for DOWN limit but only for roller shutters.
INTERMEDIATE POSITION SETUP
Stop the shutter/awning in the desired intermediate position, then press simultaneously
the UP and DOWN buttons until the motor makes a brief movement in both directions.
The intermediate position has been setup.
RECALLING THE INTERMEDIATE POSITION
Keep the STOP button pressed at least for 3 seconds: the shutter/awning will move till it
reaches the intermediate position.
ERASING THE INTERMEDIATE POSITION
Press simultaneously the UP and DOWN buttons until the motor makes a brief movement
in both directions.
BATTERY SUBSTITUTION
A. Remove the screw on the back and the cover.
B. Remove the old battery
C. Insert the new battery respecting the correct polarity
IMPORTANT: Batteries contain polluting substances. After removing, throw them in the
designated batteries collection points.