Installation - Glacier bay HD67816W-5001 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
WITH FLANGE: Place the faucet (A) through the
mounting holes in the sink until the faucet (A)
sets on top of the sink.
□
WITH DECK PLATE: Align the hole in the gasket
(C) and deck plate (B) with the mounting hole in
the sink. Place the faucet (A) through the deck
plate (B) and mounting hole in the sink until
the faucet (A) sets on top of deck plate (B).
NOTE: If the sink is uneven, use silicone under the
gasket (C).
A
A
B
C
4
2
Securing the faucet
□
Install the plastic washer (D), and metal washer
(E) onto the threaded mounting shank.
□
Thread the nut (F) onto the mounting shank.
Lock the nut (F) into position by tightening the
screws (G). Do not overtighten.
D
E
F
G