Publicidad
Idiomas disponibles
Idiomas disponibles
Install the K3 Faucet. See Figure 3.
1. Remove the hardware from the K3 faucet stem.
2. Slide the small rubber washer, the large chrome-plated metal
flange and the large rubber washer onto the threaded faucet
stem.
3. Insert the threaded faucet stem assembly into the existing faucet
hole.
NOTICE: Make sure the large chrome flange and the washer
form a tight seal against the surface of the sink top. See the
inset drawing in Figure 3.
4. From the underside of the sink, slide the large metal washer, the
locknut and the compression nut over the threaded faucet stem.
5. Tighten the connection nut against the underside of the sink to
secure the faucet in place.
Make sure
a tight seal
forms here,
at the sink.
4009 0601
Figure 3
Faucet
Threaded Faucet
Stem
Small Rubber
Washer
Chrome-plated
Metal Flange
Large Rubber
Washer
Sink Faucet Hole
Large Metal
Washer
Lockwasher
Locking Nut
2
Reconnect the cold water line from
the filtering system to the faucet stem.
See Figure 4.
1. Reconnect the water supply tubing as illustrated in Figure 4.
Turn the water back on:
1. Open the faucet and then slowly open the cold water shut off
valve.
2. To remove the air from the system run the water for 10 minutes,
or until the water runs clear of bubbles and air.
3. Check for leaks at all the fittings.
Tubing and Fitting
Assembly for
Plastic Polytubing:
a.
Slide the
compression nut
over the end of
the plastic polytubing.
b.
Slide the
white plastic
compression
sleeve over the
polytubing and
into the compression
nut.
c.
Slide the
plastic Insert
into the
Polytubing.
d.
Screw the
compression nut
onto the faucet stem
and tighten.
Figure 4
For further operating, installation, or
maintenance assistance:
Omnifilter
®
C
lean Water Solutions
293 Wright Street, Delavan, WI 53115
800-937-6664
www.omnifilter.com
After completing
a, b, and c, screw the
compression nut
onto the faucet stem
(step d).
Tubing and Fitting
Assembly for
Copper Tubing:
a.
Slide the
compression nut
over the end of
the copper tubing.
b.
Slide the
bronze compression
sleeve over the
copper tubing and
into the compression
nut.
c.
This step omitted
for copper water
supply tubing.
d.
Screw the
compression nut
onto the faucet stem
and tighten.
TM
Publicidad
