Bimar Hi-pet PTE1 Folleto De Instrucciones página 11

Fax +32 030 9904733
Lubricating the blades
For proper operation of the device, frequent lubrication of
the blades is required before each use. Add 1-2 drops of oil
onto the blades (see figure to the right) with a finger and
spread it over the entire surface of the blades. Switch on the
device (first plug it into the power outlet and then turn the
switch to pos. On.) for a short period, so that oil is
dispersed properly over all blades. Use only the oil supplied
or oil for sewing machines. Do not use hair oils, grease or
substances containing kerosene or any other solvent, as this
may evaporate and the residual oil may seep into the gears
of the blades.
The set comes with:
- 1 clipper
- no.1 comb : for cutting hair to 3mm (6) + no.2 comb :
for cutting hair to 6mm (7) + no.3 comb : for cutting hair
to 9mm (8) + no.4 comb : for cutting hair to12mm (9)
- 1 tube of lubricating oil
- 1 metal brush (12)
- 1 metal comb (14)
- 1 small brush for cleaning (16)
- 1 file (13)
- 1 nail clipper (11)
- 1 case (7)
Using the combs
Attach the desired comb onto the blades (first make sure you've
removed the 10" blade cover) with the teeth upwards,
postioning it so that the 3 hooks lock into place (you will hear a
click for the correct attachment), see figures to the side for the
proper attachment.
USE
•
Plug into the power point.
•
Press the switch while in pos. On.)
•
The device can operate continuously for up to 20 minutes, after which requires a break of
at least 20 minutes before using it again. Failure to do this may affect the performance of
the appliance.
•
If the blades get blocked, disconnect the appliance from the mains.
•
Once finished: turn the switch to pos. Off and remove the plug from the power outlet.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
11 36
/
Assembly page 11/36