Installing The Seat Heater - Dometic GROUP Waeco MagicComfort MSH300 Instrucciones De Montaje Y De Uso

MagicComfort MSH300, MSH301
6

Installing the seat heater

6.1 Tools required (fig. 1, page 2)
For installation and assembly you will need the following tools:
 Drill bit set (1)
 Drill (2)
 Screwdriver (3)
 Set of ring or open-ended spanners (4)
 Measuring ruler (5)
 Hammer (6)
 Centre punch (7)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (8) or voltmeter (9)
 Crimping tool (10)
 Insulating tape (11)
 Hot air blower (13)
 Soldering iron (14)
 Solder (15)
 Cable bushing sleeves (if necessary)
To fasten the cables you may require additional cable binders.
6.2 Installing the seat heater
Removing the seat
➤ Secure the vehicle against rolling away.
A
NOTICE!
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the uphol-
stery.
➤ Check the suitability for installation using these installation instructions
and the manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
EN
Installing the seat heater
23