Bondioli & Pavesi Global Traducción De Las Instrucciones Originales página 20

ENG
implements with high inertial loads.The torque setting is adjustable by adjusting the working
height of the springs.The edges of the linings and plates are exposed in an FFV clutch.
The torque setting is adjusted by increasing or decreasing the height "h"
35
of the springs. To increase/decrease the torque setting tighten/loosen the
eight nuts by 1/4 of a turn and check for correct operation. Repeat the procedure if
necessary. Avoid excessive tightening of the bolts - implement, tractor, or driveline
damage may occur.
FNT - FNV - FFNV - FNK COMBINATION FRICTION AND OVERRUNNING
36
CLUTCH Clutch that combines the functional characteristics of a friction
clutch and an overrunning clutch. Used on machines with high inertial loads.
Keep clear of the implement until all parts have stopped moving.
Lubricate every 50 hours of use and after storage.
Friction clutches may become hot during use. Do not touch! To avoid the
37
risk of fire keep the area around the clutch free of inflammable material and
avoid prolonged slipping of the clutch.
SHIELD DISASSEMBLY
Remove the Philips head screws.
38
Remove the base cone and the shield tube.
39
Remove the outer cone and the bearing ring.
40
SHIELD ASSEMBLY
Grease the bearing groove on inner yokes.
41
Fit the bearing ring into the groove with the reference pin facing the drive
42
tube.
Fit the outer cone, inserting the reference pin of the bearing in the hole
43
provided in the cone.
Fit the base cone with the tube, inserting the reference pin and the grease
44
fitting of the bearing in the holes provided in the cone.
Tighten the Philips head screws.
45
Use of electric powered screwdrivers is not recommended.
G9 SHIELD DISASSEMBLY
Remove the Philips head screws.
46
20