Preparation; Wiring Diagram - Homewerks 299650 Manual

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION

Before removing your current ventilation unit, verify your switch box on the wall has the required
supply wires necessary for this installation. These supply wires are power/black and neutral/white
(refer to wiring diagram below) at the switch. If you do not see both of these wires,
consult a licensed electrician.
Check area above installation location to be sure that wiring can run to the planned location and that duct work
can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere with
installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on the room
side.
Note: Installation may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local home im-
provement or hardware store.
DIMENSIONS REQUIREMENTS
Ceiling
Opening (L)
Opening (W)
7-3/4 in.

WIRING DIAGRAM

All wiring must be connected for full functionality. Do not use metal wall plate with switch.
Automatic terminal switch
Capacitor for
Motor
long life of
motor
HomewerksWW.com
Ceiling
Ceiling
Opening (H)
7-1/2 in.
4 in.
to 120V AC 60Hz
Black wire
White wire
Green wire
Electrical Box
FAN HOUSING
Housing
Dimension (L)
7-1/2 in.
To switch
To neutral
To ground
5
Housing
Housing
Dimension (W)
Dimension (H)
7-1/4 in.
3-5/8 in.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido