Dryer Description
To open the door
Press and release the front
panel in position shown
Heat Pump
Filter Unit
(cover open)
Control panel
The ON/OFF button
- if pressed when the dryer is
running: If the display shows TURNING OFF the
dryer stops. If the display shows PRESS AND HOLD
hold the botton and the display counts down 3, 2, 1
and then stops.
Press and hold again for more than 3 seconds, the
display briefly shows POWER ON .
The PROGRAMME selection buttons set the programme:
press the button corresponding to the programme you
want to select (see Start and Programmes).
The OPTION buttons/indicators: these buttons select
available options for your selected programme (see
The Controls). The indicators on the display unit next
to the bottom buttons light to show that the option has
been selected.
The START/PAUSE button/light
programme. When you press this button there will be
one beep and the display will show PAUSE . When
a programme is running, holding this button in pauses
the programme and stops the dryer.
The light is green when the programme is running,
flashing amber if the programme has been paused or
Adjustable Feet
PROGRAMME
Selection Buttons
ON/OFF
Button
starts a selected
The features
Water container
Heat Pump
Filter cover
Heat Pump Filter cover
handle (Pull to open)
Display Unit
CHILD LOCK &
OPTIONS
Buttons & Lights
flashing green if on standby waiting to start a programme
(see Start and Programmes).
Note: This light also flashes amber during the Post
Care phase of a programme.
The Display Unit gives warnings and information
about the programme selected and its progress (see
next page).
The CHILD LOCK button/icon
button after selecting your programme and any options,
this prevents the programme settings from being
changed, the display will briefly show LOCKED .
When the icon is lit, the other buttons are disabled.
Hold the button to cancel and the icon will go out, the
display will briefly show UNLOCKED .
Note: This tumble dryer, in compliance with new energy
saving regulations, is fitted with an automatic standby
system which is enabled after about 30 minutes if no
activity is detected. Press and hold the ON-OFF
button until the display briefly shows POWER ON
and the dryer then reactivates.
Rating plate
Model &
Serial
numbers
Air intake
grille
Filter
START/PAUSE
Button & Light
: Press and hold this
5
GB