Unpacking The Loudspeaker - Turbosound TCS Passive Serie Guia De Inicio Rapido

8 TCS Passive series
11.
其他的重要信息
¼'' TS
13.
14.
15.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
法律声明
12.
MUSIC Group
KLARK TEKNIK, LAB GRUPPEN, LAKE, TANNOY,
TURBOSOUND, TC ELECTRONIC, TC HELICON,
BEHRINGER BUGERA MUSIC Group IP Ltd.
© MUSIC Group IP
Ltd. 2017
保修条款
music-group.com/warranty
16.
17.
2000
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information about this or any other TURBOSOUND product,
please visit our website at turbosound.com.

Unpacking the Loudspeaker

MIDAS,
After unpacking the unit please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future re-shipment.
System Requirements – Passive and Bi-amped Loudspeakers
TCS62 2-way loudspeaker operates as a passive system and requires only one amplifi er channel. The input signal is divided between the low-frequency and high-
frequency drivers internally with a passive crossover.
TCS122 and TCS152 are switchable passive / bi-amp 2-way loudspeakers. Passive operation (full range or with a subwoofer) requires 1 amplifi er channel and 1
controller channel. The input signal is divided between the low-frequency and high-frequency drivers internally with a passive crossover. Bi-amp operation (full range
or with a subwoofer) requires 2 amplifi er channels and 2 controller channels, one for low frequencies one for high frequencies. The input signal is divided between the
low frequency and high frequency driver in the controller and the individual amplifi ed signals are fed to the speaker input.
TCS218B subwoofer has a switchable input to allow operation in parallel or discrete modes. Parallel operation connects both drivers in parallel internally. Operation
requires 1 amplifi er channel and 1 controller channel. Discrete operation connects each driver separately to the two channels of the input. Operation requires 1
amplifi er channel and a minimum of 1 controller channel.
TCS115B, TCS212B and TCS110B subwoofers operate as a passive system and require only one amplifi er channel.
Correct controller settings for all models, horn variants and operation with subwoofers can be downloaded from the website, and are also available as presents for the
LMS series controllers.
To avoid wasting amplifi er power, you should use heavy-duty speaker cable, with a minimum wire size of 1.5 mm
longer runs. Use larger wire sizes for the TCS212B and TCS218B and speakers wired in parallel. For extreme cable lengths, be aware of cable impedance and resistive
losses. Always observe the correct polarity.
Quick Start Guide 9
2 (16 AWG), and preferably 2.5 mm 2 (14 AWG) for