Publicidad
Idiomas disponibles
Idiomas disponibles
US
Instructions for installation and use
sera Biotop Nano LED Cube 60
Please read these instructions carefully and keep for future use. When forwarding this unit to third parties, this
information for use is also to be handed over.
Thank you for choosing the new sera Biotop Nano LED
Cube 60.
The newly developed LED cover with 8 powerful LED chips
in modern SMD technology is 33% brighter than the
a qua r ium covers with fluorescent tubes, whereas the
power uptake is only half as high.
Besides saving energy you will also benefit from the long
lifetime of the LED chips. Lamp replacement is no longer
required every year, and even single LED units failing hard-
ly affects brightness in the aquarium. The lighting can still
be operated without any problems until the faulty LED unit
has been re placed.
The new sera Biotop Nano LED Cube 60 of course pro-
vides the well proven 3 side view due to the bow front. This
allows watching the aquarium inhabitants easily also in the
sera Biotop Nano LED Cube 60.
General notes
• Please read these instructions carefully and keep for fu-
ture use. Also, please check your sera aquarium for
completeness.
• Please switch off all submerged technical devices by
pulling their mains plugs before touching the water with
your hand.
The aquarium is optimally packed. However, damages
due to long range transport may have occurred, as is
the case with all glass products. Therefore please
check whether the glass is in order before filling the
aquarium for the first time.
Kit includes
Plug-in complete equipment
ready to start
Aquarium with bow front (1.1)
Polished glass
Volume c. 60 liters (15.8 US gal.)
Dimensions with closed cover approx.: W 40 cm x H 47 cm
x D 46 cm (16 in. x 18.5 in. x 18.2 in.)
Aquarium cover (1.2, 1.3) with
• 8 white light LED chips with 10 * 0.2 W LEDs in SMD
technology each (1.2.1)
• neutral daylight
• 2 fans for cooling the electronic components
• built-in food flap (1.3)
• maintenance flap for the 4 chamber internal filter (1.2.2)
• openings for connecting a cooling system or accesso-
ries (1.2.4)
• sera ballast Input 100 – 240 V 50/60 Hz, Output 12 V DC
1.5 A (1.2.3)
4 chamber internal filter (1.5) with
• sera net for trapping dirt particles or fish fry (1.5.1)
• 2 filter sponges for mechanical filtration (1.5.2)
• sera siporax Professional 1.000 ml (290 g / 10.2 oz.)
for biological filtration (1.5.3)
1 liter (1 US quart) sera siporax Professional – pro-
vides as much settling space for bacteria as, for in -
stance, 34 liters (9 US gal.) of clay filter material.
• sera filter pump STP 1000 (1.5.4)
• sera heater 50 W (1.5.5)
sera flow distributor with two adjustable flow nozzles
(1.6)
100 ml (3.38 fl.oz.) sera blackwater aquatan water condi-
tioner (1.7)
50 ml (1.7 fl.oz.) sera filter biostart filter starter (1.8)
This part of the information for use refers to operating the
LED cover and the glass tank.
Please read the according information for use for operat-
ing the included devices.
Assembly and operation
First assemble the cabinet, if applicable (cabinet is not
included). Please note the instructions included with the
cabinet to do so.
Location:
Place the sera aquarium in a suitable location. Depending
on the internal decoration, the aquarium may weigh up to
100 kg (220 lb.). Therefore, the chosen location should be
perfectly even (best use a spirit level for balancing). Of
course, a mains supply should be available nearby. If you
have purchased the aquarium without a cabinet and wish
to place it on an already existing piece of furniture, it must
provide sufficient carrying capacity. The aquarium should
by no means be placed near a sunny window. Too much
sunlight does not only heat up the aquarium too strongly,
but may also cause algae blooms. The sera Biotop Nano
LED Cube 60 is equipped with a glued-on safety frame.
Place the aquarium with its frame directly onto the cabinet.
Do not use any additional mats.
Options:
• Lamps: The sera Biotop Nano LED Cube 60 is by
default equipped with 8 white LED chips. The LED
chips can be replaced separately. Please use only orig-
inal sera spare parts.
When keeping small blue fish, you may, for instance,
replace two white LED chips with blue LED chips for
enhancing the color.
8
Publicidad
