Physical Installation; Electrical Installation - Arcadia Parrot Pro Instrucciones De Seguridad, Instalación Y Mantenimiento

UK
Slide the retaining ring back onto the lamp holder. Ensuring that it is aligned
correctly, push and clip the retaining ring into place on the lamp holder. Pulling the
retaining ring clips out may help to align it onto the lamp holder. It is important
that the retaining ring engages correctly to ensure a seal with the lamp holder.
See illustration 4.

Physical installation

Select a suitable site close to your electricity supply. Do not connect appliance to
the mains supply socket during installation. This appliance is for indoor use only.
Ensure the appliance is kept in a ventilated area and away from other heat sources.
Make sure that the light from the appliance is aimed within the vivarium.
Place the luminaire in the desired position either on top of the Vivarium mesh
or screwed to the top of the Vivarium (2 screws not supplied). The luminaire
can be placed across the width of the Vivarium or along the length as shown in
illustrations 5 & 6.
Do not place any objects on top of the luminaire.
Ensure there is a minimum distance of 100mm between the lamp and the animal.
See illustration 7.
Ensure the mains lead and the luminaire are kept well out of reach of animals that
might bite or damage them.
A stand is available separately for use over parrot cages.

Electrical installation

This appliance must be earthed and the circuit must be protected by a
suitable fuse!
Before installing, ensure that the rated voltage and frequency of the Luminaire
match that of your power supply, and that the mains lead plug is fully compatible
with your mains supply socket. If in doubt, please return the unit to the point of
purchase for verification.
This appliance should be earthed to minimise the possibility of electric shock.
This appliance is equipped with an electric cord having an equipment earth wire
conductor and a grounding type plug. The plug must be plugged into a mains
supply socket that is installed and earthed in accordance with all appropriate codes
and ordinances.
Ensure the mains cable has a 'drip loop' as shown in illustration 1.
Plug the luminaire into the mains socket.
Use the switch on the driver to turn the luminaire on/off.
A suitable plug in timer may be used with this product, such as the Classica CAA01
or CAA02.
Trouble Shooting
Lamps strike almost immediately at nearly full brightness (dependant on ambient
temperature) and reach their operating temperature soon after. After switching the
fluorescent lamps off, they can be switched on straight away.
If the Luminaire does not light:
• Check that the mains power is connected and switched on both at the wall
(including Timer if used) and on the Luminaire.
• Check that the Luminaire plug is properly fused.
6