Tabla de contenido
Publicidad
INSTALLATION AND PROPER GROUNDING
UNPACKING:
1. Unpack the slicer immediately after receipt. If the machine is found to be damaged, save the
packaging material and contact the carrier within fifteen (15) days of delivery. Immediately contact
your source of the equipment. You have no recourse to damage after fifteen (15) days.
2. You should receive with the slicer, rubber feet, Globe oil, warranty card and an owner and operator
instruction manual. Contact Globe or your local supplier if you did not receive all of these materials.
TO AVOID SERIOUS PERSONAL INJURY PROPERLY
•
ALWAYS install equipment in work area with adequate light and space.
•
ONLY operate on a solid, level, nonskid surface that is nonflammable.
•
NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so may
create hazards and will void warranty.
•
NEVER operate slicer without knife cover and knife ring guard securely installed.
•
NEVER operate without all warnings attached and Globe warning card posted.
INSTALLATION:
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation
and operation if you have any questions or do not understand anything in the manual. Contact your
local representative or Globe first.
2. Remove the slicer from the corrugated box.
3. Attach rubber feet to slicer base, making sure they are firmly tightened.
NEVER USE SLICER WITHOUT RUBBER FEET INSTALLED.
4. Select location for slicer that has a level, solid, nonskid surface that is nonflammable and is in a
well-lighted work area away from children and visitors.
5. Using a drill and 3/16 drill bit install the white nylon foot retainers onto the counter where the slicer
will be sitting.
6. The foot retainers should be located at the back two feet of the slicer. The two back feet should fit
securely in the foot retainers to prevent the machine from sliding.
USE AT LEAST TWO PEOPLE TO LIFT SLICER UP TO OPERATING LOCATION.
NEVER ATTEMPT TO LIFT SLICER ALONE.
7. Make sure the slicer is level. If the slicer wobbles/rocks once it has been placed on the table or
counter adjust the rubber feet until the slicer is level.
Page 6
INSTALL SLICER IN ADEQUATE WORK AREA
Publicidad
Tabla de contenido
