CAPITAL SPORTS Shineater Manual De Instrucciones página 10

EN
10
• Step 1: Assemble a side panel (1 5) with a short side panel (3 7). Make
sure that the pieces are seamless, vertical and flush. Secure the joint
with three screws, which you screw (initially only half!) into the pre-drilled
holes.
• Step 2: Repeat step 1 with the side panels (2 6) and (4 8).
• Step 3: Place the two now ‚L'-shaped pieces on the side of the floor
and connect them to the floor panel (1 2 3 4). Use 12 screws and the
corresponding pre-drilled holes (3 on each side). Tighten these screws
firmly.
• Step 4: Insert the three inner braces into each other (they only fit into each
other in one way) and fix them together by screwing a screw in the middle
(predrilled holes):