Assembly And Operation - ESAB PT 27 Instrucciones De Uso

ASSEMBLY AND OPERATION

ASSEMBLY AND OPERATION
CUTTING HEAD PT 27, ASSEMBLY
Steel guard stand off
guide
Guide against
straight edge or
free--hand cut
Adjust guide by turning in a clockwise
direction only. This will prevent accidental
loosening of shield.
Thin gauge materials can
be cut with 1/16" (1.6mm)
torch--to--work distance
adjust to 3/16" (4.8mm) for
materials over 1/4"
(6.4mm) thick.
1/16" (1.6mm) to 1/4"
(6.4mm) torch--to--work
Steel guard protects
shield when cutting or
gouging.
- - 36 - -
If guide is too tight on
shield, open slot with
screwdriver.
If too loose, close slot with
vise or large pliers.