Maxon MAX SOL Instrucciones página 8

LIFT CORPORATION Sht. 8 of 30 DSG#
NOTE: If existing hole in battery box is already used, drill a new 9/32" hole approximately
1-1/4" below existing hole. Existing hole is for attaching metal clamp.
5. Measure and mark the location of the
controller mounting holes on outside of
the battery box door (FIG. 8-1). Refer
to FIG. 8-1A for the TS-15 controller or
FIG. 8-1B for the TS-30 controller. Next,
drill fi ve 9/32" holes in the battery box
door (FIGS. 8-1A or FIG. 8-1B). Then,
remove plug from existing hole in battery
box door (FIGS. 8-1A or FIG. 8-1B).
BATTERY BOX
© MAXON Lift Corp. 2020
Draft 12/21/2020
DOOR
FIG. 8-1
M-20-17
3.46"
9.16"
2.99"
9/32" HOLE
(5 PLACES)
HOLE LOCATIONS FOR TS-15
CONTROLLER ON OUTSIDE OF DOOR
FIG. 8-1A
4.72"
8.81"
3.70"
9/32" HOLE
(5 PLACES)
HOLE LOCATIONS FOR TS-30
CONTROLLER ON OUTSIDE OF DOOR
FIG. 8-1B
Rev. - Date: 12/09/20
EXISTING HOLE
(REMOVE PLUG)
6"
.63"
HINGE SIDE
3-1/2"
EXISTING HOLE
(REMOVE PLUG)
6"
.63"
HINGE SIDE
3-1/2"