Hinkley Luna 15609 Guia De Inicio Rapido

Top Cover
Glass
Holder
Glass
Washboard
plate
Set Screw
Ground
Nut for ground
installation
HINKLEY LIGHTING 33000 Pin Oak Parkway
Threaded Tube
Assembly
Bollard Mount
PVC
Nut
Bottom Plate
Wiring Coupler
Threaded Tube
Avon Lake, OH 44012
Installation Instructions
Family: Luna | Item No. 15609
 Start Here
Unpacking
1. Unpack the bollard from the box.
2. Remove the bollard mount, threaded tube assembly, and
PVC pipe from the box.
Luminaire Mounting
Note: If your local code requires a frost line burial deeper than
12 inches, you may purchase a 2 inch PVC pipe (sch. 40 or sch.
80) from a local supplier and cut to length as a replacement to
the provided PVC pipe.
1. Dig a hole about 12 inches or deeper, depending on your
local code.
2. Feed the wires through the PVC pipe and insert it in the
ground, make sure the PVC is sticking out of the ground
enough that the bollard mount will t on top of the PVC,
and that the bottom of the bollard mount is level with the
ground.
3. Fill in the hole around the PVC pipe.
4. Level the PVC pipe with a post level.
5. Feed the wires through the bollard mount and the
threaded tube assembly, pull the wires out through the
wiring coupler.
6. Put the bollard mount on top of the PVC pipe.
7. Tighten the three set screws on the sides of the bollard
mount.
Note: You may set the PVC in cast concrete. It is suggested
using a longer PVC pipe and conduit, that is not provided.
Cut the PVC to height after the concrete is set.
Assembly
1. Connect the xture wires and the main wires together
using wire nuts. Put the silicone glue, that's provided, in
the wire nuts to waterproof.
2. For ground installation: screw the nut (supplied) onto the
threaded tube to get the correct height adjustment. This
step is not needed for concrete or other hard surface
installations.
3. Unscrew the two screws from the top cover and remove
the cover. Let the cover hang over the edge of the xture.
4. Slide the washboard plates up to access the bottom plate.
Put the main body of the xture over the bollard mount
and threaded tube assembly.
5. Rotate the xture to the desired position.
6. Put the nut (supplied in the parts bag) on top of the
threaded tube and tighten.
7. Insert the glass into the top of the xture. Slide the glass
holders in the xture.
8. Insert a bulb or LED engine. See LED instructions to install.
9. Put the top cover back on and tighten the two screws.
(p)800.442.5539 / (f ) 440.653.5555 www.hinkleylighting.com