Swing-N-Slide Tunnel Twister Slide Instrucciones De Ensamblaje página 4

Tunnel Twister ssembly Instructions
Fig. 1
Entrance Section - 14 bolts
Fig. 1a
Exit Section - 13 bolts
flanged lip
flat lip
90˚ Section - 13 bolts each
4
A. ENTRANCE SECTION, 90° SECTION
AND EXIT SECTION
NOTES:
• At least two individuals are needed to assemble the
Tunnel Twister Slide.
• To aid in aligning holes when assembling sections,
insert a screwdriver through adjacent holes to maintain
hole alignment.
1. Identify each slide section as either (1), (2), (3), (4),
(5), or (6) as marked on the lip of each piece.
2. Assemble entrance section using pieces (1) & (2), one
90° section using pieces (3) & (4), and the exit section
using pieces (3) & (5). Join sections using a 3/4" hex
head bolt, two flat washers, and a loc nut at each hole
junction (FIG. 1), (Fig. 1a), & (Fig. 1b). NOTE:
Fasten each loc nut finger tight until the entire slide is
assembled. Each time you join parts be sure each
flanged lip is mating with a flat lip.
NOTE: Hand tighten the loc nuts only.
3/4" bolt
washer
washer
loc nut
Fig. 1b