Swing-N-Slide Tunnel Twister Slide Instrucciones De Ensamblaje página 6

Tunnel Twister ssembly Instructions
Fig. 3
Fig. 3a
C. Slide Support and Entry
1. Align the mounting panel to the previously
assembled entrance section (Fig. 3). Attach the
mounting panel to the entrance section at the hole
locations indicated in (Fig. 3a) using one 1" bolt,
two washers and one loc nut per hole as indicated
in (Fig. 3b).
NOTE: Hand tighten the loc nuts only.
Fig. 3b
1" bolt
washer
washer
loc nut
6