Vertilux VTi CELTIC RF Manual De Programación página 7

Adding an additional remote control or
"cloning" a channel
A previously programmed remote control can be used in order to add a new remote control or
operating channel. Also, you can copy one channel to another in the same remote control using
this procedure.
1. Using the previously programmed
remote, select the desired channel using the
channel selector button, then press and hold the
stop button for about
2.
Using the new remote, select the desired
channel using the channel selector
then press the up button
Vertilux shades are now paired with the new
remote or channel.
Changing to tilt or jog mode
Tilt or jog mode
initiates a short motor movement when pressing the up or down buttons.
tilt or jog mode
The is convenient for Venetian Blinds, Wood Blinds and
since it allows the jogging of the slats in a more precise way. When this mode has been
programmed, the up or
to its upper or lower limits, otherwise when you press the
short movements.
Repeat the same procedure if you want to erase the
1. Press and hold the
until the motor "jogs".
2. stop button
Release the
about 2 s. The motor will
tilt or jog mode
The has been programmed.
vertilux.com
6
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
Vertilux
5 s until the motor "jogs".
button, and
until the motor "jogs".
down button must be pressed for
stop button for about 5 s
and press it again for
"jog" again.
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
Neolux
3 s to make the motor move continually
up and down button
tilt or jog mode.
STOP
BUTTON
UP
BUTTON
Dual Shades
®
the motor will do
STOP
BUTTON
STOP
BUTTON