S&P MBE Serie Manual De Instrucciones página 17

Maintenance.
- Before manipulating the heater battery, make sure
that it is disconnected from the main supply. Prevent
the possibility of anyone else connecting it while it is
being manipulated.
- The apparatus must be regularly inspected. These
inspections should be carried out bearing in mind the
machine's working conditions, in order to avoid dirt or
dust accumulating.
- All maintenance and repair work should be carried out
in strict compliance with each country's current safety
regulations.
Recycling.
EEC Standards, together with the responsibility we
should assume with future generations in mind, oblige us
to recycle all the materials we can. Therefore please
deposit all left-over material and packaging in their
corresponding recycling containers and hand in the
replaced machines to the nearest handler of this type of
waste product.
If you have any queries about S&P products, please
contact our After-Sales Service Network if you are in
Spain or your local S&P dealer in any other country. If in
doubt, please visit our Web-page
Technical data:
The electric batteries comply with EC Standards
The electric batteries incorporate 2 thermal protectors
fitted as standard: one for automatic reset at 60ºC and
another one at 120 ºC with manual reset.
MBE electric heating battery
Supply voltage:
Single-phase: 1/230V AC, 50Hz
Three-phase: 2/400V or 3/400V AC, 50Hz
Protection rating: IP43
IBE electric heating battery
Supply voltage:
Three-phase: 2/400V or 3/400V AC, 50Hz
Protection rating: IP43
www.solerpalau.com
Index for wiring diagram
REF DESCRIPTION
1 General ON/OFF switch (heater and fan)
2 Air volume controller
3 Post-ventilation timer
4
Heater relay
5 Fan relay
6 The electrical installation must include a
double pole switch with a contact clearance of
at least 3mm
7a Night set-back adjustment
7b Limitation adjustment (ºC)
7c
Note: 10ºC per grading with duct temperature
sensor TGK360
7c (1) Minimum limit sensor
7c (2)
Maximum limit sensor
7c (3) Inactive limits
8 Set point adjustment (PULSER front cover)
Time switch contact (night set-back 0...10ºC)
9a
9b Time switch contact (night set-back 5ºC)
10
See below connection and selection of the
configuration according to utilisation
10a Internal set-point and sensor
10b Internal set-point and external sensor
10c External sensor and internal set-point
10d
External duct sensor and TGR430 as set-point
10e External duct sensor and built-in potentiometer
as set-point
10f Room control using TGR 430 as sensor and
set-point
11 Safety overheat
control - factory wired)
11a Automatic thermostat
11b Manual reset thermostat
12
Attention: closed contact between terminals G-
G = output controller at 0 (heater not supplied)
13 Temperature sensor to limit output temperature
14
Connection to G1-G2 for external set-point
adjustment
15
Connection to G1-G3 for internal set-point
adjustment
16 Internal adjustment
17 See below connection and selection of the
configuration according to utilisation
17a External duct sensor and built-in potentiometer
as set-point
17b Room control using TGR 430 as sensor and
set-point
17c
Room external
potentiometer as set-point
17d External duct sensor and TGR430 as set-point
17e External duct sensor and internal set-point
17f Output temperature limit sensor Min/Max
18
Active
19 Inactive
thermostat (temperature
sensor and built-in