Technical Data - Eldom wind WG50 Manual De Instrucciones

GENERAL DESCRIPTION
A. Protective mesh - rear
B. Nut
C. Airscrew
D. Nut securing the
airscrew
E. Protective mesh - front
F. Base feet
G. ArmH. Shank
I. Height regulation locki
J. Base
K. Arm assembly lock
L. Oscillation switch
M. Body
N. Switch and gears: I, II and II

TECHNICAL DATA

- power: 45W
- supply voltage: 230V ~ 50Hz
ASSEMBLY AND THE APPLIANCE OPERATION
Before the first use, unpack the unit and put
particular elements together.
- unscrew screws from the base feet (F) and
couple the feet of the base
together (cross), fig. 01
- using the screws couple the feet (F) with the
collar of the base (J), fig. 02
- remove the shield from the base (J), fig. 03
- couple the arm (G) with the body (M)
together with the shank (H). To do
the above, slide the arm into the shank
(if it is necessary loosen the lock (K)) and lock it
by tightening the lock (K)
- unscrew the nuts (B,D) from the body's shaft (M)
- fix the rear protective mesh (A). Adjust the holes in the mesh to the
clamps of the body, fig. 04
- fix the nut (B), twisting it clockwise, fig. 5
INSTRUCTION MANUAL
ROOM FAN WG50
A
B
C
F
EN
D
E
G
H
I
J
8
EN